If you set FND to (0-0) then the first numbers decade will be (0). It does nothing to the rest of the numbers.
Lets say FND is set to (0-2) and the ones place digits in the P-1 wheel cell is set to 25. The program will then
use these numbers as the first number in each line.
02 05 12 15 22 25 32 35
Not all of these will pass through the generating process depending on the values set in P-2.
Lets say that we set FND to (0-0) and play digits 13 in P-1. This allows the generator to use
the numbers 01 and 03 as first numbers. LND works the same way, but deals with the last or
highest number in the set. If we set LND to (2-3) and P-5 to 246 then the numbers 22-24-26
32-34-36 can be used as the 5th number.
Here is a full example
P-1 = 3
P-2 = 5
P-3 = 7
P-4 = 2
P-5 = 8
actual numbers that will be wheeled in each position
P-1 = 03-13-23-33
P-2 = 05-15-25-35
P-3 = 07-17-27-37
P-4 = 02-12-22-32
P-5 = 08-18-28-38
Lines generated
1st = 03 05 07 12 18
2nd = 03 05 07 12 28
3rd = 03 05 07 12 38
4th = 03 05 07 22 28
5th = 03 05 07 22 38
6th = 03 05 07 32 38
7th = 03 05 17 22 28
8th = 03 05 17 22 38
etc...
Notice the red numbers, if we take the first line in the process it would be 03-05-07-02-08 because of the 02 in P-4 it jumps
to the second possible number in P-4 which is 12 and the 5th number must be greater than the number in position 4. so the first
line generated that will be passed is 03-05-07-12-18. This process is carried out until the last possible line is drawn, 23 25 27 32 38
for 21 lines total for this setup. Now if we set FND to (0-0) then the first number must be less than 10 and since we have on one
digit in the P-1 cell then it limits the lines to only those that start with 03 as the first number. If we set FND to (0-1) then we have
the two first numbers 03-13 so only the lines that have the 03 or 13 will be allowed to pass. This is a very simpleones place digit
wheel. Once one chooses the digits for the wheel cells the numbers could be built using a pen and paper. DMP-HT is not a system
but a tool that replaces pen and paper. The analysis tools are the main focus as they allow one to analyze the data quicker then if
doing it by hand. If a wheel cell is left blank then all 10 digits 0 to 9 will be used in that position but like in the example above some
may not pass due to the number in the position before it and the number in the position after it.
RL