Welcome Guest
Log In | Register )
You last visited April 24, 2018, 8:46 pm
All times shown are
Eastern Time (GMT-5:00)

Power Ball settings and suggestions for Digit Master.

Topic closed. 197 replies. Last post 5 years ago by LotOfJack.

Page 14 of 14
51
PrintE-mailLink
Avatar
Jacksonville, Florida
United States
Member #129275
June 14, 2012
25 Posts
Offline
Posted: October 30, 2012, 8:26 pm - IP Logged

What are the filter definitions in the Mene2/Bin-G menu, the ones in the lower left. I know some but would like to know the others.

Thanks

    Avatar
    Thread Starter

    United States
    Member #59354
    March 13, 2008
    4772 Posts
    Offline
    Posted: November 1, 2012, 3:37 am - IP Logged

    What are the filter definitions in the Mene2/Bin-G menu, the ones in the lower left. I know some but would like to know the others.

    Thanks

    lotofjack

    1/1 = the number of groups with consecutive hits from previous draw

    0/0 = the number of groups with consecutive misses from previous draw

    0/1 = the number of groups that missed in previous draw but expected to hit in next draw

    1/0 = the number of groups that hit in previous draw but expected to miss in next draw

    1x1 = a single group hit that does not have another group that hits before or after.
           Example.  If group (A) hits and (B) misses then (A) counts as a 1x1

    2x1 = two consecutive groups that hit such as (AB) (BC) etc...

    3X1 = Three consecutine groups hits (ABC)

    1X0, 2x0, 3x0.
    These are the same as above but count consecutive misses.  Example. If groups all three groups
    (DEF) all miss then it counts as a 3x0.

    Odd  = number of odd groups that are expected to hit in the next draw.  ACEGI) are odd groups

    Even = number of even groups that are expected to hit in the next draw. (BDFHJ) are even groups

    G-M  = Group mirrors  A-F, B-G, C-H, D-I, E-J,  if any of these pairs hit it counts as a GM

    T-G  = total groups that provide all the numbers

    F-5 = First 5 groups (ABCDE)

    MPM = Matching middle pair.  IF E and F both hit or miss it counts as a MPM.  If one hits and
           the other misses than it's not a MPM

    B-5 = Back five groups.  (FGHIJ)

    Clr = Clear all settings

    B-T = Back test mode, single draw backtest.  Same as Run but skips the top draw in the database.
           Used to test the program code.

    Run = builds the strings of groups that fit all the settings used.

    End = ends the program, ie Exit.

    The Bin-D is almost the same and you should be able to figure them out from what I have listed here

    RL

    ....

      Avatar
      Jacksonville, Florida
      United States
      Member #129275
      June 14, 2012
      25 Posts
      Offline
      Posted: November 1, 2012, 3:39 pm - IP Logged

      Thanks RL, greatly appreciated.

      LotOfJack

         
        Page 14 of 14